[evil_genius_180]

If I have problems with the rounder, it's because I forgot to do something. I have a duplicate vert somewhere or a face "inside the mesh" (when using extrude) or I forgot to have a polygon at the end point that I'm trying to round. I especially do that last one a lot because I tend to round edges before mirroring. Otherwise, I have no issues at all with it. I've always wanted a rounder tool, but TrueSpace either didn't have one or didn't have one that worked right, depending on the version of the software you were using. The one in TS7 couldn't round curves, which made it useless.